Your own VPN

Your own VPN, for you and your team

Run WireGuard or OpenVPN on a VPS in Malmö with full root access, and reach your servers, admin panels and office network over an encrypted tunnel from anywhere—without opening them to the whole internet.

  • Full root access, your keys

    Install WireGuard, OpenVPN or anything else you like. It is your server, so you hold the keys and decide who gets access.

  • Keep admin panels off the internet

    Put SSH, databases and internal tools behind the tunnel, so only your own devices can reach them.

  • IPv6 for every device

    Every plan includes a /64 of IPv6, enough to give every device in your tunnel its own address.

  • Hosted in Sweden

    The server runs on our own hardware in Malmö, under Swedish and EU law.

Plans for a VPN

A VPN for a person or a team needs very little: Standard handles it comfortably. Performance Alloy adds redundant networking and faster Intel Xeon v4 cryptography if many devices use it at once.

Recommended for a team VPN
Processor

Intel® Xeon® E5-2470 v2

Memory

ECC DDR3

Storage

HDD · RAID 10

Network

1 Gbit

VC-S Micro

vCPU
2
Memory
8 GB
Storage
250 GB
Transfer
10 TB
€7.99/mo

(€1.00/GB RAM)

Deploy now

VC-S Small

vCPU
4
Memory
16 GB
Storage
500 GB
Transfer
15 TB
€15.49/mo

(€0.97/GB RAM)−3%

Deploy now

VC-S Medium

vCPU
6
Memory
24 GB
Storage
750 GB
Transfer
20 TB
€22.49/mo

(€0.94/GB RAM)−6%

Deploy now
Best value

VC-S Large

vCPU
8
Memory
32 GB
Storage
1 TB
Transfer
25 TB
€28.99/mo

(€0.91/GB RAM)−9%

Deploy now

To reach your VPN from any network, the server needs an IPv4 address. It is €1.00 per month, ticked by default when you order.

Available add-ons

  • Dedicated IPv4 addressAll tiers Available on every tier and plan of this service. Add IPv4 connectivity. IPv6-only by default.€1.00/moeach

All prices are shown excluding VAT, where applicable. Discount percentages are estimated and rounded, so actual savings may vary slightly by plan.

Up and running in four steps

  1. 1

    Deploy a server

    Choose a plan and an operating system. It is ready in minutes, with full root access.

  2. 2

    Install WireGuard or OpenVPN

    Install the VPN software from your distribution's packages and generate keys for the server.

  3. 3

    Add your devices

    Create a configuration for each phone, laptop or router your team uses, and give each one an address from your IPv6 range.

  4. 4

    Connect

    Your devices now reach your servers and services through the tunnel, wherever you are.

Read the full step-by-step guide

Planning a VPN or proxy service for customers?

Our plans are for your own and your team's traffic. Public VPN, proxy and exit services are not covered by them, and need a written agreement with our sales team before you start. Read the fair-use policy.

Talk to sales
In writing

The parts people search for, and rarely find

Mail ports, jurisdiction, routing, uptime. Each of these is a published policy or a fact you can verify, so you can check it before you order rather than discover it after.

  • Protected IP reputation & reverse DNS

    Outbound port 25 (SMTP) is filtered on every server, so our IP ranges stay clean for everyone. To send mail from your applications and websites, use an SMTP relay on port 587, which works out of the box. Direct sending on port 25 is reviewed case by case and normally only granted to established customers with a clear need. Reverse DNS (PTR) on IPv4 and IPv6 is yours to set directly in the panel.

  • Swedish company, Swedish data centre, Swedish and EU law

    Melonslab is a trade name of Hypefox AB, registered in Sweden, and every server runs on our own hardware in a Malmö data centre. Your data is governed by Swedish and EU law; the US CLOUD Act does not reach us. A full Article 28 GDPR data processing agreement applies to every plan.

  • RPKI-validated routing, verifiable by anyone

    We run our own network, HypefoxNet (AS214365), with RPKI Route Origin Validation enforced: invalid announcements are dropped, not forwarded. Upstream AS39351 puts you one hop from several Tier-1 carriers. Check it yourself on bgp.tools or PeeringDB.

  • 99.5% monthly uptime, backed by credits

    We commit to 99.5% monthly uptime for the infrastructure and network behind your server, in a published SLA. If we miss it, you claim a service credit against that month's fee; the SLA sets out the steps. Planned maintenance is announced in advance on our status page.

Common questions

Have more questions? support@melonslab.com